Capacitor Energy Calculator
Find how much energy a charged capacitor stores, and the electric charge on its plates, from its capacitance and the voltage across it.
| Stored energy | 0.6875 J |
|---|---|
| Stored charge | 55 mC |
| Energy in milliwatt-hours | 0.190972 mWh |
Link to this calculation – copied!
Formula
Q = C × V
| Symbol | Meaning |
|---|---|
| E | Stored energy, in joules (J) |
| C | Capacitance, in farads (F) |
| V | Voltage across the capacitor, in volts |
| Q | Stored charge, in coulombs (C) |
How to Use This Calculator
- Enter the Capacitance (µF). 1 F = 1,000,000 µF.
- Enter the Voltage (V).
- Press Calculate. Results also update automatically as you type.
Worked Example
Using the values pre-filled in the calculator above:
| Capacitance | 2,200 µF |
|---|---|
| Voltage | 25 V |
| Stored energy | 0.6875 J |
|---|---|
| Stored charge | 55 mC |
| Energy in milliwatt-hours | 0.190972 mWh |
About This Calculation
A capacitor stores energy in the electric field between two conductive plates. Charging it from zero to voltage V moves a charge Q = CV onto the plates, and because the voltage rises gradually as the charge builds, the energy stored is half of Q × V, giving E = ½CV². Energy therefore grows with the square of voltage: doubling the voltage stores four times as much energy.
A 2,200 µF electrolytic capacitor charged to 25 V holds about 0.69 J. That is tiny compared with a battery (an AA cell stores roughly 10,000 J), but a capacitor can release it in microseconds, which is why capacitors power camera flashes, defibrillators, pulsed lasers and the start-up of motors. Supercapacitors rated in farads at a few volts bridge the gap and are used for backup power and regenerative braking.
The energy figure is also a safety guide. Large capacitors in power supplies, microwave ovens and amplifiers can hold a dangerous charge long after the equipment is unplugged. Discharge them through a suitable resistor before working on a circuit, and never rely on a capacitor's voltage rating being exactly reached: run it at no more than about 80% of the rated voltage for long life.
Frequently Asked Questions
- Why is there a ½ in the capacitor energy formula?
- As the capacitor charges, its voltage rises from zero to V, so on average each bit of charge is moved through only half the final voltage. That averaging gives the factor of one half.
- How long does a capacitor take to charge?
- Through a resistor, it reaches about 63% of the supply voltage after one time constant, τ = RC. Use the RC time constant calculator to work it out.