Free online formula calculators

RC Time Constant Calculator

Enter the resistance and capacitance to find the time constant τ, how long the capacitor takes to charge to 63% and 99%, and the -3 dB cutoff frequency.

RC Time Constant Calculator
kΩ
µF
Result
Time constant τ (to 63.2%)1 s
Time to 99%4.6052 s
Five time constants (99.3%)5 s
Cutoff frequency0.159155 Hz
τ in readable units1 s

Link to this calculation

Formula

τ = R × C
V(t) = Vs × (1 − e−t/τ)
t99% = τ × ln(100) ≈ 4.6 τ
fc = 1 ÷ (2π × R × C)
SymbolMeaning
τTime constant, in seconds
RResistance, in ohms
CCapacitance, in farads
VsSupply (step) voltage
fcCutoff frequency of an RC filter, in hertz

How to Use This Calculator

  1. Enter the Resistance (kΩ).
  2. Enter the Capacitance (µF).
  3. Press Calculate. Results also update automatically as you type.

Worked Example

Using the values pre-filled in the calculator above:

Inputs
Resistance10 kΩ
Capacitance100 µF
Results
Time constant τ (to 63.2%)1 s
Time to 99%4.6052 s
Five time constants (99.3%)5 s
Cutoff frequency0.159155 Hz
τ in readable units1 s

About This Calculation

When a capacitor charges or discharges through a resistor, the voltage does not change linearly but follows an exponential curve. The time constant τ (tau), equal to R × C in seconds when R is in ohms and C in farads, sets the speed of that curve. After one τ a charging capacitor reaches about 63.2% of the supply voltage; a discharging one falls to 36.8% of its starting value.

Each further time constant closes 63.2% of the remaining gap: about 86.5% after 2τ, 95% after 3τ, 98.2% after 4τ and 99.3% after 5τ. Engineers usually treat a capacitor as fully charged after five time constants. Reaching exactly 99% takes ln(100) ≈ 4.6τ. A 10 kΩ resistor with a 100 µF capacitor has τ = 1 second.

The same RC pair forms a simple low-pass or high-pass filter, with a cutoff frequency of 1/(2πRC) at which the signal is reduced by 3 dB (to about 70.7% of its amplitude). RC timing is used for switch debouncing, power-on reset delays, 555 timer circuits and smoothing PWM signals. Real electrolytic capacitors have tolerances of ±20% or more, so treat calculated times as approximate.

Frequently Asked Questions

Why 63% for one time constant?
The charging curve is 1 − e−t/τ. At t = τ this equals 1 − 1/e ≈ 0.632, so the capacitor is 63.2% of the way to the supply voltage.
Is a capacitor ever fully charged?
Mathematically the curve never quite reaches 100%, but after 5τ it is within 0.7%, which is fully charged for practical purposes.
How much energy does the charged capacitor hold?
Use the capacitor energy calculator, which applies E = ½CV².

Category: Electrical & Engineering. Found a problem with this calculator? Let us know.