Free online formula calculators

Voltage Divider Calculator

Find the output voltage of a resistive voltage divider from the input voltage and the two resistor values, along with the current it draws.

Voltage Divider Calculator
V
kΩ
kΩ
Result
Output voltage (Vout)3.837 V
Division ratio (Vout / Vin)0.3197
Divider current0.816327 mA
Power in R16.6639 mW
Power in R23.132 mW

Link to this calculation

Formula

Vout = Vin × R2 ÷ (R1 + R2)
I = Vin ÷ (R1 + R2)
SymbolMeaning
VinInput voltage across the whole divider
R1Top resistor, between Vin and the output
R2Bottom resistor, between the output and ground
VoutUnloaded output voltage across R2

How to Use This Calculator

  1. Enter the Input voltage (Vin).
  2. Enter the R1 (top).
  3. Enter the R2 (bottom).
  4. Press Calculate. Results also update automatically as you type.

Worked Example

Using the values pre-filled in the calculator above:

Inputs
Input voltage (Vin)12 V
R1 (top)10 kΩ
R2 (bottom)4.7 kΩ
Results
Output voltage (Vout)3.837 V
Division ratio (Vout / Vin)0.3197
Divider current0.816327 mA
Power in R16.6639 mW
Power in R23.132 mW

About This Calculation

A voltage divider is two resistors in series across a supply, with the output taken from the junction between them. Because the same current flows through both, the supply voltage is split in proportion to the resistances. The output is the fraction R2 ÷ (R1 + R2) of the input: with 10 kΩ on top and 4.7 kΩ below, a 12 V supply gives about 3.84 V.

Dividers are used to scale a voltage down for a microcontroller's analog input, to bias transistors, to set the output of adjustable regulators, and to read sensors such as thermistors and light-dependent resistors whose resistance changes with conditions. A potentiometer is simply a divider with an adjustable tap.

The formula assumes nothing is drawing current from the output. Any load connected to Vout sits in parallel with R2 and pulls the voltage down. As a rule of thumb, keep the divider current at least ten times larger than the load current, or buffer the output with an op-amp. A divider is not a power supply: it wastes energy continuously and its output sags under load, so use a regulator when you need to power a circuit. Lower resistor values make a stiffer divider but draw more current, which matters in battery-powered devices.

Frequently Asked Questions

How do I choose R1 and R2 for a target voltage?
Pick R2, then R1 = R2 × (Vin − Vout) ÷ Vout. For 5 V down to 3.3 V with R2 = 20 kΩ, R1 ≈ 10.3 kΩ, so 10 kΩ is a close standard value.
Can I use a voltage divider to power a device?
Generally no. The output voltage drops as soon as the device draws current. Use a linear regulator or a buck converter instead.
How do I check the resistor current and wattage?
This calculator shows both. You can also check individual values with the Ohm's law calculator.

Category: Electrical & Engineering. Found a problem with this calculator? Let us know.