Free online formula calculators

Series Resistor Calculator

Enter the resistances connected end to end and the supply voltage. The calculator gives the total resistance, the circuit current and each resistor's voltage drop.

Series Resistor Calculator
ΩSeparate values with commas, spaces or new lines.
V
Result
Total resistance790 Ω
Current11.3924 mA
Total power0.102532 W
Voltage drop per resistor100 Ω: 1.139 V; 220 Ω: 2.506 V; 470 Ω: 5.354 V

Link to this calculation

Formula

Rtotal = R1 + R2 + … + Rn
I = V ÷ Rtotal,  Vk = I × Rk
SymbolMeaning
RtotalEquivalent resistance of the chain, in ohms
RkIndividual resistance values
VSupply voltage across the whole chain
ICurrent, the same through every resistor

How to Use This Calculator

  1. Type or paste the Resistances (Ω). Separate values with commas or spaces.
  2. Enter the Supply voltage (V).
  3. Press Calculate. Results also update automatically as you type.

Worked Example

Using the values pre-filled in the calculator above:

Inputs
Resistances100, 220, 470
Supply voltage9 V
Results
Total resistance790 Ω
Current11.3924 mA
Total power0.102532 W
Voltage drop per resistor100 Ω: 1.139 V; 220 Ω: 2.506 V; 470 Ω: 5.354 V

About This Calculation

Resistors are in series when they are connected end to end so that the same current must pass through each one in turn. Their resistances simply add: a 100 Ω, a 220 Ω and a 470 Ω resistor in series behave exactly like a single 790 Ω resistor. The total is always larger than the largest individual value.

Because the current is identical everywhere in a series chain, the supply voltage is shared out in proportion to resistance. The largest resistor takes the largest share of the voltage and also dissipates the most power. The individual drops always add back up to the supply voltage, which is Kirchhoff's voltage law in action and a handy check on any measurement.

Series connections are used to build up a value you do not have in your parts drawer, to make voltage dividers, and to limit current. Remember that one open-circuit component breaks the whole chain, which is why old-style series Christmas lights went dark when a single bulb failed. Resistor tolerances also add up, so a chain of 5% parts is still only accurate to about 5%.

Frequently Asked Questions

Does the order of series resistors matter?
Not for the total resistance or current. Order only changes which junction sits at which voltage, which matters if you are tapping off a voltage between them.
How is this different from resistors in parallel?
In parallel the current splits between branches and the total resistance is lower than the smallest resistor. Use the parallel resistor calculator for that case.

Category: Electrical & Engineering. Found a problem with this calculator? Let us know.